2lt pinto mods - cam & conrods

[Craig]

[Miniliteman]

Hi Craig,

no I haven't got any turbo experience at all.
From one of the Vizard books I remember that he advises a low (std) overlap cam for a turbocharged car at least for not-race applications. The low overlap helps get low-rev boost up and the turbo gives the extra high-end rpm power.

[rorym]

I would be increasing both the valve size up to 44.5 and 38.1mm and running a high lift short duration say 280-285 degree shaft with say 104 lobe centres and with a 38DGMS and a decent exhaust it'll be a good thing

Danny[/quote]

Danny,
Can you point me in the right direction for this cam..name?..I have looked everywhere but cant find anything at 104 degrees.
Also..44mm inlet?..maybe I have been reading too much but it appears 21/4N is not the go and EN52B is...also need the right length?..110mm not 111.5mm?
Confusion reigns.
Rory

[Avon]

[Miniliteman]