some pinto stuff made in sweden (our race enigne page5)

by **escortinadriver** » Sun Feb 10, 2008 9:14 am

iron_man,

What are the 47mm valves from? Length?

Thanks.

by **iron_man** » Sun Feb 10, 2008 10:48 am

by **iron_man** » Mon Feb 11, 2008 7:49 am

i got the answer on the cam followers from tg-motor
the one on the topp is made in steel billet and the other one is coated

by **iron_man** » Mon Feb 11, 2008 4:34 pm

by **iron_man** » Tue Feb 12, 2008 3:43 am

i have work on the head tonight and this is what it locks like now

and i did mark out the valve seat so i dont go to far

if am not to busy tomorrow i maybe get the seat done

by **iron_man** » Wed Feb 13, 2008 4:07 am

seat is done :grin:

and it looks like this

so what do you all think of it?

by **Roger Miller** » Wed Feb 13, 2008 5:50 am

http://www.rsmotorsport.com.au/forums/v ... .php?t=463

Plenty of info here.

by **iron_man** » Wed Feb 13, 2008 6:38 am

by **iron_man** » Thu Feb 14, 2008 5:46 am

workt a little more but no picture of it tonight.
but here is the seat angle

by **escortinadriver** » Thu Feb 14, 2008 2:59 pm

Are you offsetting the exhaust

If so, can you give some instructions. diagrams etc?

Thanks, Shaun

by **iron_man** » Fri Feb 15, 2008 3:22 am

by **iron_man** » Fri Feb 15, 2008 3:41 am

i feel quite ready for a first flow test with the intake and after that i will fill up the floor and if it dosen`t make me satisfied then i will fill up the cember

so what do you guys think of it?

by **iron_man** » Fri Feb 15, 2008 7:07 am

by **escortinadriver** » Fri Feb 15, 2008 5:10 pm

by **iron_man** » Fri Feb 15, 2008 7:07 pm

by **Roger Miller** » Sat Feb 16, 2008 3:50 pm

http://www.turboford.net/cgi-bin/ultima ... 8;t=000020
.
.
.
.
.
.
.
See above link for info

by **Neville Bertwistle** » Sat Feb 16, 2008 9:03 pm

Roger,

If that's an alloy Esslinger head then it would be a 2.3 Pinto head - right?

by **Neville Bertwistle** » Sat Feb 16, 2008 9:04 pm

by **Roger Miller** » Sat Feb 16, 2008 10:08 pm

by **iron_man** » Mon Feb 18, 2008 5:25 am

some pinto stuff made in sweden (our race enigne page5)

Who is online