Clutch Fork Pivot Bolt

[Gary P.]

I am after a Clutch fork pivot bolt for a 2 Litre Pinto. The hex head in the one on the racecar is totally stuffed and I had to remove it with vice grips. So i'm after one with the hex in reasonable condition.

[ozstang65]

Tried a bolt shop? Might be close to one of the standard Unbrako ones?? Either that or get a standard socket head cap screw and get a spacer machined up for it.

[Darren W.]

From memory an old door hinge pin is the right diameter, just cut to length was my fix on a HT cap screw. But I think this type is still avail. from FORD as I reconized one a few months back in the YA - YE parts bins but didn't write down the location.

[jsa]

gary,

Might get lucky with a shoulder socket head set screw.

Or as suggested, sleeve on SHSC.

[bmw02rally]

Gary,

I might have something as my old Pinto and Clutch is all just sitting there.....

I'll have a look tonight!

Mark

[Gary P.]

[Gary P.]

[bmw02rally]

No luck this time though mate! Mr. King and I just had a look, it must still be on my alloy bellhousing that went to Mr McNab.

Sorry dude!

[Gary P.]

Thanks mate, Mr King told me personally!!

[ozstang65]

[jsa]

Compare this

[stuart]

Does anyone know what size and height it should be?

[Danny M]

For a 2lt or a 1600

[stuart]

2LT