Alloy 711M Block
Posted: Fri Feb 20, 2009 9:47 pmI have the above block for sale.
It's never been used, and is fully machined, just requiring liners for final piston selection.
Block height is approx 20cm, and bore 8.5cm.
The reason this block was not used originally is that when machined the crossflow push-rod holes, camshaft bearings, dizzy hole, were cut, and the pushrod holes will require sleeving as there is some breakthrough to the water jacket. An easy job to have them sleeved or plugged as required.
This makes the block ideal for a T/C, or a Crossflow.
I have standard end-caps for the block, but would suggest using steel ones.
If interested, and for images of the block and a price discussion, contact me directly.
Steve
It's never been used, and is fully machined, just requiring liners for final piston selection.
Block height is approx 20cm, and bore 8.5cm.
The reason this block was not used originally is that when machined the crossflow push-rod holes, camshaft bearings, dizzy hole, were cut, and the pushrod holes will require sleeving as there is some breakthrough to the water jacket. An easy job to have them sleeved or plugged as required.
This makes the block ideal for a T/C, or a Crossflow.
I have standard end-caps for the block, but would suggest using steel ones.
If interested, and for images of the block and a price discussion, contact me directly.
Steve