Revolution rims supplier
Posted: Tue Jul 09, 2013 1:13 pmDoesn't anyone know of a supplier of revolution rims in aus?
RS Motorsport :: Classic Speed Restored
Carrying on from \"The Works Escorts\" forums of years past, RS Motorsport is dedicated to those small Fords from the Golden Era of Motorsport, namely the 60's, 70's and 80's.
http://www.rsmotorsport.com.au/forums/
Revolution rims supplier
http://www.rsmotorsport.com.au/forums/viewtopic.php?f=26&t=5216
Page 1 of 1
Posted: Tue Jul 09, 2013 1:13 pmRe: Revolution rims supplier
Posted: Thu Jul 11, 2013 7:52 amI could not find one in aus palmside in nz or hass in Ireland have them at a good price at the moment
Re: Revolution rims supplier
Posted: Mon Jul 15, 2013 9:00 pmThanks jim anyone have any idea what offset ect I'd need to run 15x8s on the rear and 15x7s on the front I have no Idea when it comes to this stuff unfortunately
Re: Revolution rims supplier
Posted: Tue Jul 16, 2013 7:40 pmArched or unarched?
If unarched, I'd go +12 on the front (although you can squeeze +6 if you roll your arches and your tyres aren't too wide). On the rear you'd need to push the extra width inboard, meaning something like +24p. Personally I don't see the point of that, so I'm sticking with 7" ET12 all round.
Wheels are expensive, so check that these figures work for you before you buy. Measure, then remeasure etc.
If unarched, I'd go +12 on the front (although you can squeeze +6 if you roll your arches and your tyres aren't too wide). On the rear you'd need to push the extra width inboard, meaning something like +24p. Personally I don't see the point of that, so I'm sticking with 7" ET12 all round.
Wheels are expensive, so check that these figures work for you before you buy. Measure, then remeasure etc.
Re: Revolution rims supplier
Posted: Thu Jul 18, 2013 12:44 amIt's unarched with rolled guards thinking I'm better off sticking to 7s all round