Page 1 of 1
Twin DCOE Sync
Posted:
Wed Jan 28, 2015 2:48 pmby MK1_Oz
What tool are you using to sync your carbs? Due to room restrictions I dont think I will get the snail type one in there so a remote one would be the go. No, my ears are not good enough to do it without a tool...
Re: Twin DCOE Sync
Posted:
Wed Jan 28, 2015 5:18 pmby Danny M
All you need is a blade screwdriver and a torch
Re: Twin DCOE Sync
Posted:
Wed Jan 28, 2015 7:21 pmby ozstang65
As Danny said, just remove the plug over the progression holes and shine a torch down the throat or whatever it takes to show the butterfly through the holes. Adjust until they are aligned. Simples.
Re: Twin DCOE Sync
Posted:
Wed Jan 28, 2015 9:58 pmby Clayton
I use a 40mm pvc 90 deg bend with one end cut down and rapped with electrical tape (fits into ram tube)
The other end stands vertical and slips over the flowmeter.
Works for me.
Clayton
Re: Twin DCOE Sync
Posted:
Wed Jan 28, 2015 10:18 pmby Danny M
Lining up the butterflies is the easiest and most accurate