RS Motorsport :: Classic Speed Restored

Just wondering if any knows if I can get different fuel connections that link the 2 carbs - trying to get something that is higher/taller or angled at 45 degrees so the fuel hose doesn't look to foul the block breather box or the throttle bracket.I'm running twin 40's (Delorttos)

Tried to upload pcis but can't get it down to suitable size

Might not suit what you're after, but long ago I had a set of 40's, each with a single fuel hose inlet (not joined directly between the carbs) I found a fuel filter that had 1 inlet and 2 outlets so plumbed that in.

Yeah, I think so, many years ago now. Possibly subaru or vw is ringing a bell...very distantly though...

Try Carbtech in Redcliffe, 07 32843061. I've found them quite helpful with most things.

ReCarb are in Brisbane also. Have a good range of Dellorto parts and are very helpful

Ph: Dave 0754933788

What manifold are you using as I have run 40's on a pinto and had no clearance issues with the breather.

Inlet Manifold is a Lynx.

I think I can get a 'Y' piece to put into the fuel line and it then runs to the 2 Carbs. All I need then is another (single) Banjo to replace the 'T' piece I'm currently using.